Operating Rules For Fast Uplink - HP procurve series 4100gl Management And Configuration Manual

802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)
802.1p Spanning-Tree Protocol (STP)
13-30
In figure 13-12, STP is enabled and in its default configuration on all switches,
unless otherwise indicated in table 13-5, below:
Table 13-5.STP Parameter Settings for Figure 13-12
STP Parameter Switch "1"
1
Switch Priority 0
(Fast) Uplink No
1
This setting ensures that Switch "1" will be the primary root switch for STP in figure 13-12.
2
This setting ensures that Switch "2" will be the backup root switch for STP in figure 13-12.
With the above-indicated topology and configuration:
Scenario 1: If the link between switches "4" and "2" goes down, then the
I
link between switches "4" and "3" will begin forwarding in as little as ten
seconds.
I Scenario 2: If Switch "1" fails, then:
• Switch "2" becomes the root switch.
• The link between Switch "3" and Switch "2" begins forwarding.
• The link between Switch "2" and the LAN begins forwarding.

Operating Rules for Fast Uplink

A switch with ports configured for fast uplink must be an edge switch and
I
not either an interior switch or the STP root switch.
Configure fast-uplink on only the edge switch ports used for providing
redundant STP uplink connections in a network. (Configuring Fast-Uplink
STP on ports in interior switches can create network performance prob-
lems.) That is, a port configured for STP uplink should not be connected
to a switch that is sequentially further away from the STP root device. For
example, switch "4" in figure 13-12 (page 13-29) is an edge switch.
I Configure fast uplink on a group (two or more) of redundant edge-switch
uplink ports where only one port in the group is expected to be in the
forwarding state at any given time.
Switch "2" Switch "3"
2
1 32,768 (default)
No No
Switch "4"
32,768 (default)
Ports 3 & 5