HP procurve series 4100gl Management And Configuration Manual page 296

Multimedia Traffic Control with IP Multicast (IGMP)
CLI: Configuring and Displaying IGMP
IGMP Configuration
for the Selected
VLAN
IGMP Configuration
On the Individual
Ports in the VLAN
Figure 12-2. Example Listing of IGMP Configuration for A Specific VLAN
N o t e
12-8
Enabling or Disabling IGMP on a VLAN. You can enable IGMP on a
VLAN, along with the last-saved or default IGMP configuration (whichever
was most recently set), or you can disable IGMP on a selected VLAN. Note
that this command must be executed in a VLAN context.
Syntax: [no] ip igmp
For example, here are methods to enable and disable IGMP on the default
VLAN (VID = 1).
HPswitch(config)# vlan 1 ip igmp
HPswitch(vlan-1)# ip igmp
HPswitch(config)# no vlan 1 ip igmpDisables IGMP on VLAN 1.
If you disable IGMP on a VLAN and then later re-enable IGMP on that VLAN,
the switch restores the last-saved IGMP configuration for that VLAN. For more
on how switch memory operates, see Chapter 5, "Switch Memory and Config-
uration".
You can also combine the
mands, as described in the following sections.
Enables IGMP on VLAN 1.
Same as above.
command with other IGMP-related com-
ip igmp