Additional printer setup
Installing hardware options
Installing an optional tray
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional hardware or
memory devices sometime after setting up the printer, then turn the printer off, and unplug the power cord
from the electrical outlet before continuing. If you have any other devices attached to the printer, then turn
them off as well, and unplug any cables going into the printer.
Turn off the printer using the power switch, and then unplug the power cord from the electrical outlet.
Unpack the tray, and then remove any packing material.
Remove the tray from the base.
Remove any packing material from inside the tray.
Insert the tray into the base.
Place the tray near the printer.