Removing and Replacing the 743 Board Computer
This section provides step-by-step instructions for removal and replacement of a single
VME slot and dual VME slot 743 board computer.
Preliminary Requirements
Perform the following procedure before you remove the board computer from its VMEbus
chassis:
1
Perform the steps in the Preliminary Procedures section of this chapter.
Removal
Follow these steps to remove the board computer from its VMEbus chassis:
1
Loosen the captive screws (labeled 1 and 2 in Figure 5-2) at each end of the board com-
puter which hold the computer in the VMEbus chassis.
2
Raise both ejector levers outwards and pull the board computer forward out of the
VME chassis.
Figure 5-2
Removing and Replacing the 743 Board Computer
Captive Screws: Single and Dual Slot 743
Field Replaceable Units
4
3
2
1
5-9