Cisco SPA 525G2 Administration Manual page 33

Getting Started
Using IVR on the Cisco SPA 301 and Cisco SPA 501G IP Phone
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide
Number Option
170 Recites the HTTP port on which the web server listens. Defaults to 80.
180 Recites the IP multicast address (used by the Cisco SPA 9000 to
communicate with the IP phone).
220 Recites the method of call control (SIP or SPCP).
221 Set call control—enter the value for the call control method you want,
then press #:
•
0: SIP
•
1: SPCP
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
73738 Restores the phone to the factory default software and settings.
Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
begin the restore process.
87778 Restore the phone's user settings to the default. (Clears all user settings
(Cisco SPA such as speed dials.)
501G)
Enter 1 to confirm, or * to exit. If you chose to reset, hang up to exit and
begin the restore process.
732668 Reboot the phone. After entering #, hang up to begin rebooting.
111 Set a static IP address. Enter the address (use * to enter the "." value),
then press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE
disabled, you receive an error message.
121 Set a netmask. Enter the address (use * to enter the "." value), then
press #.
To save, press 1; to review, press 2; to re-enter, press 3; to exit, press *.
NOTE
disabled, you receive an error message.
DHCP must be disabled to use this option; if DHCP is not
DHCP must be disabled to use this option; if DHCP is not
1
21