Configuring Domain And Internet Settings; Configuring Restricted Access Domains - Cisco SPA 525G2 Administration Manual

Configuring Security, Quality, and Network Features

Configuring Domain and Internet Settings

STEP 5
Configuring Domain and Internet Settings
STEP 1
STEP 2
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide
Parameter
DTMF Tx Method
DTMF Tx Volume
for AVT Packet
Click Submit All Changes.

Configuring Restricted Access Domains

You can configure restricted access domains. If you enter domains, the Cisco IP
phones respond to SIP messages only from the entered servers.
Log in to the configuration utility.
Click Admin Login and advanced.
Description
Select the method to transmit DTMF signals to the far end:
InBand, audio video transport (AVT), INFO, Auto, InBand+INFO,
or AVT+INFO. InBand sends DTMF using the audio path. AVT
sends DTMF as AVT events. INFO uses the SIP INFO method.
Auto uses InBand or AVT based on the outcome of codec
negotiation.
Defaults to Auto.
Allows you to manually configure the AVT Tx volume. The value
of this parameter is inserted into the volume field of the
payload in the AVT packet.
Values are based on the AVT specification as described in RFC
RTP Payload for DTMF Digits, Telephony Tones and
2833,
Telephony Signals
. According to RFC 2833, the volume field is
represented by 6 bits, and describes the power level of the
tone, expressed in dBm0 after dropping the sign.
Valid range for this parameter is 0 to 63. If the provisioned
value is negative, it will be negated first. Thereafter, if the value
is beyond the high limit of 63, it will be clipped to 63.
The default value is 0, and is the recommended setting.
However, some gateways do not accept this volume setting. If
the gateway does not accept the value of 0, the DTMF tone is
not relayed to the remote end. As a workaround for the phone
to interoperate with those gateways, you can change the value
to a value greater than 0.
5
128