Concluding Steps - Fujitsu PRIMERGY RX2520 M1 Upgrade And Maintenance Manual

Figure 208: Connecting front panel cables
Ê Connect the front panel cable to the system board.
Ê Run the front panel cable through the cable clamps as shown.
Ê If applicable, connect the front VGA cable to the front VGA connector of the
system board as described in section
page 316.

13.1.1.4 Concluding steps

"Installing the fan box" on page 171
Ê
"Reassembling" on page 59
Ê
"Connecting the server to the power source" on page 64
Ê
"Switching on the server" on page 66
Ê
"Verifying system information backup / restore" on page 77
Ê
Ê Store your server's system information on the Chassis ID EPROM
integrated into the front panel board. For further information on how to obtain
and use the ChassisId_Prom Tool, refer to section
Prom Tool" on page
RX2520 M1
97.
Upgrade and Maintenance Manual
Front panel and external connectors
"Installing the front VGA connector" on
"Using the Chassis ID
315