6
Power supply units
Safety notes
V
CAUTION!
Do not disassemble the power supply unit. Doing so may cause
●
electric shock.
Areas around the power supply unit may remain extremely hot after
●
shutdown. After shutting down the server, wait for hot components to
cool down before removing the power supply unit.
When installing a power supply unit, ensure that the connector of the
●
power supply unit is not damaged or bent.
If the power supply unit is hard to remove, do not pull it out by force.
●
The power supply unit is heavy, so handle it carefully. If you drop it by
●
mistake, injuries may result.
For further safety information, please refer to chapter
●
information" on page
6.1
Basic information
The PRIMERGY RX2520 M1 server can be equipped:
– with up to two power supply units that automatically adjust to any mains
voltage in the range of 100 VAC to 240 VAC
I
Power redundancy is possible with two power supply units . The effective
power of the power supply units may not differ.
V
CAUTION!
The server supports a mains voltage in the range of 100 VAC to
240 VAC. You may only operate the server if its rated voltage range
corresponds to the local mains voltage.
RX2520 M1
37.
Upgrade and Maintenance Manual
"Important
101