Table of Contents
Advertisement
4.1.3
Locating the defective component
After determining the error class by the CSS or Global Error indicators (see
section
"Determining the error class" on page
the front panel and system board allow you to identify the defective component.
I
For further information, refer to the "ServerView Suite Local Service
Concept (LSC)" manual.
4.1.3.1
Local diagnostic indicators on the front
Ê Check the CSS indicator on the front and connector panels of the server:
I
In addition to local diagnostic indicators, CSS or Global Error LEDs
indicate, if the defective component is a customer or field replaceable
unit (see section
4.2
Shutting down the server
V
CAUTION!
For further safety information, please refer to chapter
information" on page
I
This step is only required when upgrading or replacing non-hot plug
components.
Ê Inform the system administrator that the server will be shut down and put
offline.
Ê Terminate all applications.
Ê Perform the required procedures described in the preliminary steps of each
upgrade or maintenance task.
"Verifying and configuring the backup software solution" on page
Ê
Ê In case of Multipath I/O environments, please refer to section
server maintenance in a Multipath I/O environment" on page
"Removing backup and optical disk media" on page
Ê
Ê Shut down the server.
I
If the system is running an ACPI-compliant operating system,
pressing the On / Off button will perform a graceful shutdown.
RX2520 M1
"Determining the error class" on page
37.
Upgrade and Maintenance Manual
Basic hardware procedures
50) local diagnostic indicators on
50).
"Important
71.
71.
"Note on
72.
51
Advertisement
Table of Contents
