Removing The Memory Air Duct - Fujitsu PRIMERGY Econel 200 S2 Options Manual

Preparation
Figure 6: Removing the system fan cable
Ê Disconnect the plug of the system fan cable from the system board (see
circle, connector Rear Fan).
4.4

Removing the memory air duct

For the installation of additional memory modules or installation of a second
processor the traverse with the memory air duct has to be removed.
Ê Remove the side cover as described in
page 17.
Ê Remove the processor fan 2 as described in
processor fan 2" on page
Ê Remove the system fan as described in
on page 19.
Econel200 S2
Removing the memory air duct
section "Opening the server" on
18.
section "Removing the system fan"
Options Guide
section "Removing the
21