Fujitsu PRIMERGY Econel 200 S2 Options Manual page 48

Installing an expansion board
Ê Close the slot locking bar and press on the two green locking levers at the
server's rear side until they engage.
Ê If required, connect the cables to the expansion board and other compo-
nents.
Ê Install the system fan as described in
page 51.
Ê Close the server, connect it to the mains, and switch it on as described in
section "Closing the server" on page 53
I
Please check the relevant PCI slot settings in the BIOS manual. If
necessary, change the settings. Please read the documentation for the
installed expansion board.
Pay attention to the allocation of the PCI interrupts. You will find further
information in the Technical Manual for the system board D2530 (PDF file
available on the ServerBooks DVD).
48
Expansion boards in PCI slots
section "Installing the system fan" on
et seq. .
Options Guide
Econel200 S2