Fujitsu PRIMERGY Econel 200 S2 Options Manual page 34

Installing an accessible drive
Figure 14: Screws of the middle bay
Ê Remove the two screws of the depending bay and push the dummy module
from the inside through the front panel.
V
CAUTION!
Keep the dummy module for future use. If the drive is removed again and
not replaced with a new drive, the dummy module must be reinstalled
due to cooling, to comply with applicable EMC regulations (regulations
on electromagnetic compatibility) and to protect against fire.
Ê Unpack the new drive, and make the desired settings. You should read the
accompanying documentation supplied with the drive beforehand.
Ê Push the accessible drive into the free bay.
Ê Fasten the accessible drive with two screws.
Ê Connect the data cable to the accessible drive (see the cabling plans in the
Appendix).
Ê Connect the power cable to the accessible drive (see the cabling plans in the
Appendix).
Ê Install the system fan as described in
page 51.
34
section "Installing the system fan" on
Options Guide
Accessible drives
Econel200 S2