Fujitsu PRIMERGY Econel 200 S2 Options Manual page 47

Expansion boards in PCI slots
Figure 26: Removing the slot cover
Ê Remove the PCI slot cover.
V
CAUTION!
Keep the slot cover for further use. If the expansion board is removed
again and not replaced with a new one, the slot cover has to be
reinstalled to comply with applicable EMC regulations and satisfy
cooling requirements and fire protection measures.
Ê Unpack the new expansion board, and make the desired settings. You
should read the accompanying documentation supplied with the expansion
board beforehand.
Ê Install the expansion board into the PCI slot and press it carefully into the
associated plug-in location on the system board until it engages properly.
Econel200 S2
Installing an expansion board
Options Guide 47