Fujitsu PRIMERGY Econel 200 S2 Options Manual page 40

Installing the 5-inch multibay
Figure 21: Connecting the cables
Ê Connect the power cable plugs P9 (floppy) and P12 (CDROM) to the rear
side of the drives.
Ê Connect the floppy cable and the CDROM cable to the rear side of the
drives.
Ê Push the 5-inch multibay into the lowest bay. Lead the cables carefully into
the interior of the chassis. Avoid deadlocks or damage of the cables.
Ê Fasten the 5-inch multibay with two screws.
Ê Straighten the floppy and the CDROM cable and close the cable clamp.
Ê Install the system fan as described in
page 51.
Ê Install the processor fan 2 as described in
fan 2" on page
Ê Close the server, connect it to the mains, and switch it on as described in
section "Closing the server" on page 53
40
52.
Options Guide
section "Installing the system fan" on
section "Installing the processor
et seq. .
Accessible drives
Econel200 S2