Fujitsu PRIMERGY Econel 200 S2 Options Manual page 43

Hard disk drives
Figure 23: Installing the SATA hard disk drive
Ê Push the assembled drive with the rails into the free bay until the EasyClick
rails are locked in position.
Ê Attach the power cable and the SATA cable to the new drive (see the cabling
plans in the Appendix).
Power cable:
plug P18 must always be connected to the lowest SATA hard disk. In this
case: remove the plug P18 from the first SATA hard disk, and connect the
plug to the second SATA hard disk. Connect plug P17 to the first SATA hard
disk.
SATA cable:
Connect the SATA cable to the system board and the SATA hard disk. Cable
SATA hard disk 1 belongs to system board connector SATA1, SATA hard
disk2 to connector SATA2, SATA hard disk3 to connector SATA3, SATA hard
disk4 to connector SATA4 (position of the connectors see system board foil
D2530 in the side cover).
I
You will find further SATA cables stored in the cable clamps (see
arrow).
Ê Close the server, connect it to the mains, and switch it on as described in
chapter "Completion" on page 49
Econel200 S2
Installing SATA hard disk drives
et seq. .
Options Guide 43