Installing The 5-Inch Multibay - Fujitsu PRIMERGY Econel 200 S2 Options Manual

Accessible drives
Ê Install the processor fan 2 as described in
fan 2" on page
Ê Close the server, connect it to the mains, and switch it on as described in
section "Closing the server" on page 53
7.2

Installing the 5-inch multibay

Ê Remove the side cover as described in
page 17.
Ê Remove the processor fan 2 as described in
processor fan 2" on page
Ê Remove the system fan as described in
on page 19.
Figure 15: Screws of the lowest bay
Ê Remove the two screws of the lowest bay and push the dummy module from
the inside through the front panel.
Econel200 S2
52.
18.
Options Guide
Installing the 5-inch multibay
section "Installing the processor
et seq. .
section "Opening the server" on
section "Removing the
section "Removing the system fan"
35