Fcc Statement, Applicable In U - Leica iCON robot 60 User Manual

1.8

WARNING
WARNING
Labelling iCON
robot 60/iCON
builder 60
Labelling internal
battery GEB222
Labelling internal
battery GEB212
iCON robot 60/iCON builder 60, Safety Directions
FCC Statement, Applicable in U.S.
The greyed paragraph below is only applicable for products without radio.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Leica Geosystems for compliance
could void the user's authority to operate the equipment.
006274_001
005043_001
005044_001
Type: iCR6X
Art.No.:
7900XX
S.No.:
Equip.No.: 1234567
123456
Power: 12V / 7,4V ,1A max.
Leica Geosystems AG
CH-9435 Heerbrugg
Manufactured: 20XX
Made in Origin
Complies with FDA performance standards for laser products
expect for deviations pursant to Laser Notice No. 50, dated
June 24, 2007
This device complies with part 15 of the FCC Rules. Operation
Is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
19