Electromagnetic Compatibility (Emc); Fcc Statement (Applicable In The U.s.) - Leica Rugby 100 User Manual

Electromagnetic
Compatibility (EMC)
The term "electromagnetic
compatibility" is taken to mean the
capability of the laser unit to function
smoothly in an environment where
electromagnetic radiation and
electrostatic discharges are present,
and without causing electromagnetic
disturbances to other equipment.
WARNING:
Electromagnetic radiation can
cause disturbances in other
equipment.
Although the laser units meet the strict
regulations and standards which are in
force in this respect, Leica
Geosystems cannot completely
exclude the possibility that other
equipment may be disturbed.
CAUTION:
There is a risk that disturbances
may be caused in other equipment if
the laser unit is used in conjunction
with accessories from other
manufacturers, e.g. walkie-talkies,
mobile phones.
Precautions: Use only the equipment
and accessories recommended by
Leica Geosystems. When combined
with the laser unit, they meet the strict
requirements stipulated by the
guidelines and standards.
CAUTION:
Disturbances caused by
electromagnetic radiation can result in
the tolerance limits for measurements
being exceeded.
Safety Directions
Although the laser meets the strict
regulations and standards which are in
force in this connection, Leica
Geosystems cannot completely
exclude the possibility that the laser
unit may be disturbed by very intense
electromagnetic radiation, e.g. near
radio transmitters, walkie-talkies,
diesel generators, power cables.
Check the plausibility of results
obtained under these conditions.
FCC Statement (applicable in
the U.S.)
WARNING:
This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential
installation.
This equipment generates, uses and
can radiate frequency energy and, if
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is no
guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
• Increase the separation between
the equipment and the receiver.
25
Rugby 100-1.5.0en