Connecting To A Personal Computer - Leica iCON robot 60 User Manual

4.2

Install Leica USB
drivers
Connect USB cable
to computer for the
first time step-by-
step
iCON robot 60/iCON builder 60, Operation

Connecting to a Personal Computer

Windows Mobile Device Center (for PCs with Windows Vista or Windows 7/Windows 8
operating system) is the synchronisation software for Windows mobile-based pocket
PCs. Windows Mobile Device Center enables a PC and a Windows mobile-based pocket
PC to communicate.
Step Description
1. Start the PC.
2. Insert the Leica iCON USB card.
3. Run the SetupViva&GR_USB_XX.exe to install the drivers necessary for
Leica devices. Depending on the version (32bit or 64bit) of the operating
system on your PC, you have to select between the three setup files
following:
• Setup_iCON_iCR60_iCB60-USB_32bit.exe
• Setup_iCON_iCR60_iCB60-USB_64bit.exe
• Setup_iCON_iCR60_iCB60-USB_64bit_itanium.exe

The setup has to be run only once for all Leica iCON devices.
4. The Welcome to InstallShield Wizard for Leica Viva & GR USB drivers
window appears.

Ensure that all Leica iCON devices are disconnected from your PC
before you continue!
5. Next>.
6. The Ready to Install the Program window appears.
7. Install. The drivers will be installed on your PC.

For PCs with Windows Vista or Windows 7/Windows 8 operating
system: If not already installed, Windows Mobile Device Center will
be installed additionally.
8. The InstallShield Wizard Completed window appears.
9. Check I have read the instructions and click Finish to exit the wizard.
006312_001
Step Description
1. Start the computer.
2. Plug the GEV223 cable into TPS instrument.
3. Turn on the TPS instrument.
4. Plug the GEV223 cable into the USB port of the computer. The Found New
Hardware Wizard starts up automatically.
5. Check Yes, this time only. Next>.
2
4
3
31