Autodetect Behaviour - Leica iCON robot 60 User Manual

Insert and remove a
USB stick step-by-
step
4.8
Description
Communication-
Handle
iCON robot 60/iCON builder 60, Operation
Step Description
4. Close the lid and turn the knob to the horizontal position to lock the commu-
nication compartment.
5. To remove the SD card, open the lid of the communication compartment
and gently press on the top of the card to release it from the slot.
Step Description

The USB stick is inserted into the USB host port
inside the Communication side cover of the instru-
ment.
1. Turn the knob on the Communication side cover to
the vertical position to unlock the communication
compartment.
2. Open the lid of the communication compartment
to access the communication ports.
3. Slide the USB stick with the Leica logo facing you
firmly into the USB host port until it clicks into posi-
tion.

Do not force the USB stick into the port.
4. If desired, store the lid of the USB stick on the
underside of the compartment lid.
5. Close the lid and turn the knob to the horizontal position to lock the
compartment.
6. To remove the USB stick, open the lid of the compartment and slide the USB
stick out of the port.

Autodetect Behaviour

• The instrument incorporates an autodetect behaviour and automatically detects
the following devices:
• CommunicationHandle
• radios
• Whenever a device is attached, the instrument responds with two short beeps.
• Whenever a device is removed, the instrument responds with one long beep.
• CommunicationHandle is automatically detected by the instrument when it is
attached.
• Long range Bluetooth Handles appear as "C2" identification while they are searched
for pairing. Example reading: "iCR62 1623207 C2"
• CCD2 = Bluetooth shown as "C2
5a
4
3
(6)
006317_001
36