Leica iCON robot 60 User Manual page 32

Connect to
computer via USB
cable step-by-step
iCON robot 60/iCON builder 60, Operation
Step Description
6. Check Install the software automatically (Recommended). Next>. The
software for Remote NDIS based LGS TS Device will be installed on your
computer
7. Finish.
8. The Found New Hardware Wizard starts up automatically a second time.
9. Check Yes, this time only. Next>.
10. Check Install the software automatically (Recommended). Next>. The
software for LGS TS USB Device will be installed on your computer.
11. Finish.
12. For PCs with Windows Vista or Windows 7/Windows 8 operating system:
Windows Mobile Device Center starts up automatically. If it does not start
automatically, start Windows Mobile Device Center.
006313_001
Step Description
1. Start the PC.
2. Plug the GEV223 cable into iCON robot 60/iCON builder 60 instrument.
3. Turn on the iCON robot 60/iCON builder 60 instrument.
4. Plug the GEV223 cable into the USB port of the computer.

For PCs with Windows Vista or Windows 7/Windows 8 operating system:
Windows Mobile Device Center starts up automatically. If it does not start
automatically, start Windows Mobile Device Center.
If Windows Mobile Device Center is not installed, run the Mobile device
Center installation program.
5. Press Connect without setting up your device.

The folders on the iCON robot 60/iCON builder 60 instrument are displayed
under File Management. Press Browse the content of your device. The
folders of the data storage device can be found in either of the following
folders:
• Leica Geosystems\iCON\res\data
• SD Card
• USB memory device
2
4
3
32