1.4 Power ON
1) Connect an AC power cable to the unit being inspected.
2) Connect the VG-819 cable to the unit being inspected. Any input connector is acceptable.
3) Turn on the POWER switch of the VG-819 to generate an output of Signal 32.
4) There is a vacation switch (a seesaw switch) at the right side of the unit being inspected. Confirm that
this switch is set at the "
being inspected.
5) A screen can be checked within about 4 seconds after the POWER key ON. The LED is then lit in green
(For factory mode, LED is yellow) and a screen is displayed.
1.5 Inspection
1.5.1 How to Control a Menu
1) User menu
3
4
–
+
EXIT
EXIT
EXIT
" side. Press the POWER key at the right end of the front to turn on the unit
NO OSM
SELECT
NO OSM
An item is select by the 3,4 keys.
A tab is select by the 3,4 keys.
5-6