Power On And Off Modes ���������������������������������������������������33 Operating Range For The Remote Control; Power Indicator Status ��������������������������������������������������������33 Showing The Information Osd; Energy Mode ����������������������������������������������������������������������33 Switching Between Sound Modes; And [Quick Start] Are Set To [Off] - NEC E988 User Manual

Power On and Off Modes
Power indicator status
The monitor operates as follows in On mode when no signal is input from an external device.
Mode Normal operation
Power indicator
Energy Mode
The three following modes are available on the monitor.
HDMI1
Setup
Energy Mode
Power Save
Quick Start
Auto Power Down
LAN and RS-232C can be selected for the monitor control. The way the energy modes operate varies depending on the
selected control method.
When [RS-232C] is selected for control, [Power supply] and [Quick Start] are set to [Off]
Home/Office mode
• When no signal is input, "No signal" is displayed and the monitor enters the auto standby mode after a while.
• When a signal is input into the selected input terminal, the On mode is resumed.
When the AV terminal and VGA (YPbPr) terminal are selected, the On mode is not resumed even if a signal is input. In this
case, enable the Quick Start function. (With this function enabled, the On mode is resumed.)
Retail mode
• The monitor does not enter the energy-saving mode when no signal is input. (The On mode is maintained.)
If the monitor power is turned off while the monitor is in auto standby mode, it will still be in auto-standby mode
NOTEE:

when it is turned on again.
Auto power save mode
(On mode) (energy-saving mode)
Lit blue
Move Select
OK
Blinking red
Home
Retail
Office
Return
MENU
English - 33
Auto standby mode
(energy-saving mode)
Lit red
EXIT
EXIT