Setting Mode - REMEHA Gas 310 ECO Technical Information

13

SETTING MODE

13.1 User level setting mode (X [[)
Setting mode is used to change various settings to suit
individual requirements. The required code is selected
by pressing the m key until ! appears in the code win-
dow. Select the required code with the s key. Now
press the [+] key to increase a setting or the [-] key to
decrease a setting.
Press the e key to store the new setting. The new
value will flash twice in the t window to confirm the
setting.
Code Description
!
Flow temperature setpoint, see section
13.1.1
@
Pump run on setting, see section 13.1.2
A Boiler control setting, see section 13.1.3
table 17 Settings mode user level
Important!!
g
only be on design engineers advice.
13.1.1 Flow temperature (!)
The required flow temperature is adjustable from 20 to
90°.
The following diagram shows a typical example of this
procedure:
fig. 26 Setting flow temperature
pdf
62560.indd 37 62560.indd 37
Changing @ and A should
C o d e R e se t
Zoek de Code 1. op
(continu brandende stip)
C o d e R e se t
1x
Opslaan van de nieuwe
temperatuur in het geheugen
Setting range and explanation if necessary
20 to 90°
(boiler thermostat setting, also top heating
curve setting if external sensor is used)
00
= pump run on 10 seconds
01 - 15 = pump run on in minutes
99
= continuous pump operation
Control mode (modulating-on/off-etc.)
C o d e
Gewenste temperatuur instellen met ' ' en ' '
C o d e
Terugkeren naar de bedrijfssituatie
37
Factory set-
ting
80
05
31
R e se t
1x
R e se t
18-6-2009 13:14:59 18-6-2009 13:14:59