Quotation Specification; Delivery Options - REMEHA Gas 310 ECO Technical Information

4.3 Quotation specification

- Cast aluminium - sectional pre-mix gas fired fully
condensing, modulating floor standing boiler
- Sectional heat exchanger manufactured from cast
aluminium
- Maximum operating pressure of 6 bar
- Maximum operating temperature of 90°C
- Ultra low NOx (max. 35 ppm at 0% O
- Pre-mix, fully modulating (20-100%) gas burner with
unique gas/ air ratio control for maximum efficiency
- Intelligent advanced boiler control 'abc
hensive operating, service and fault diagnostic facility
- No minimum flow requirement (see section 7.4.5)
- Available as conventional flue or room sealed operation
- Capable of remote BMS control (0 -10V modulating,
on/ off or high/ low option)
- Socket for advanced service diagnostics (for PC/ PDA
connection)
- Supplied fully factory assembled and tested
Execution 'left-hand'
fig. 04 Installation options
04.31H.79.00004
I = Front (service side)
A = Short side (alternative orientation of the instrument
panel)
Supplied By www.heating spares.co Tel. 0161 620 6677
)
2
® ' c/w a compre-
Gas 310 ECO
Remeha Gas 310 ECO
- Powder coated enamel steel casing BS; RAL colour:
2002 (red); 9023 (grey)
- Rigid steel box frame
- Suitable for use with Natural gas only
- Supplied as standard with on/ off switch, temperature
indication, flow, return, heat exchanger block and flue
gas sensors
- Supplied as standard with indicating module No. 1
lock-out indication (Volt free), shut down indication
(Volt free), boiler on indication (24 Volt AC)
- Efficiencies up to 109% (NCV/ Hi)
- Manufactured to ISO 9001
- CE approved

4.4 Delivery options

Available in 5 section sizes, in "left-hand" or "right-hand"
versions each with 2 instrument panel positions:
Gas 310 ECO
Execution 'right-hand'
The service side with the inspection cover on the heat
exchanger is considered to be the front of the boiler.
With a "left-hand" version, the flow, return and flue
connections are on the left of the boiler as you face
the front (service side). On a "right-hand" version, the
flow, return and flue connections are on the right of the
boiler as you face the front (service side). The boiler
instrument panel can be rotated to face the front or the
short side of the boiler (front will be standard unless
stated on the purchase order) (see fig. 04).
12