Setting The Manual Mode; Displaying The Measured Values; Reading The Various Current Values - REMEHA Quinta Pro Installation, User And Service Manual

9 Settings
Fig.53 Setting manual mode
2x
bar
2x
9.3

Displaying the measured values

54

9.2.6 Setting the manual mode

In some cases, it may be necessary to set the boiler to manual mode, for
example when the controller has not yet been connected. The boiler can
be set to automatic or manual mode via the
1. Press the two
until the symbol flashes in the menu bar.
2. Press the
either the text
pressure sensor is connected).
or the minimum flow temperature value.
3. Press the
mode.
4. To confirm, press the
The boiler is now set to manual mode.
5. Press the
tion display.
AD-0000080-01
The control unit continually registers various values from the boiler and the
connected sensors. These values can be read on the control panel of the
boiler.

9.3.1 Reading the various current values

The following current values can be read in the information menu
= Status.
= Sub-status.
= Flow temperature (°C).
= Return temperature (°C).
= Calorifier temperature (°C).
= Outside temperature (°C) (only with outside sensor).
= Solar boiler temperature (°C).
= Internal set point (°C).
= Ionisation current (μA).
= Fan speed (rpm).
= Water pressure (bar (MPa)).
= Supplied relative heat output (%).
The current values can be read as follows:
keys at the same time and then press the
key; the display will show:
with the current water pressure (only if a water
or keys to temporarily increase this value in manual
key.
key twice to leave this menu and return to the opera­
symbol. Proceed as follows:
key
:
123157 - v.07 - 10082015