SoundCraft Si Performer User Manual page 57

Setting Oscillator and Monitor Patches
It is possible to change other output patches in the system from within the appropriate MENU:
OSC: Oscillator re-patching is initiated from the OSC menu; the method is as for bus
•
output patches however the oscillator may only be patched to one destination.
MONITOR OUT: It is possible to assign additional line outputs for the monitor L and R
•
from the MONITOR menu; the method is similar as for bus output patches however the
monitor left and right will be patched together as a stereo pair and only one 'paired'
destination is allowed.
Patching Replay Filtering
It is possible to isolate patching changes from the automation from the EDIT SHOW menu to
prevent the automation from changing system patching when a cue is recalled. To isolate an item
scroll to the desired list item, press the encoder and select Isolate.
Auto Complete Boundaries
Boundaries exist to prevent AUTO COMPLETE overwriting too many channels and mix buses
or physical inputs and outputs. The boundaries are nominally grouped in eights (e.g. mic
inputs 1-8, mic inputs 9-16, input channels 17-24, input channels 25-32).
However they may be smaller if the boundary group is not divisible by 8 — e.g. mix 1-8 is
a logical group of 8 and could be patched to line out 1-8; but mix 9-14 is a group of 6 so
the boundary for mix buses stops there.
If you start mix bus 9 patched to line out 9 then 'AUTO COMPLETE', the process will stop at
mix bus 14 to line out 14. However if you started with mix bus 1 to line out 9 then' AUTO
COMPLETE', the process will stop at mix bus 8 to line out 16.
Soundcraft Si Performer User Guide V1.1 1112
57