SoundCraft Si Performer User Manual page 13

Aux Outputs
Group Outputs
Line Outputs
Aux Outputs
Group Outputs
Soundcraft Si Performer User Guide V1.1 1112
Line Outputs
The 16 Line outputs are wired as shown and are fully balanced allowing long cable
runs to other equipment. If connecting to un-balanced destinations the Signal –
(cold) pin should be grounded.
AES Output:
This is a balanced 2-channel digital output using a single XLR wired as per the
balanced line outputs. Although it is possible to use standard balanced audio
cable with AES signals it is recommended to use AES cable which has the correct
110R impedance.
Headphones
The PHONES output is a 3-pole 6.35mm (1/4") jack, wired as a stereo output
as shown, ideally for headphones of 32Ω or greater; 8Ω headphones are not
recommended. The headphone socket is found under the front edge, close to
fader 1.
MIDI IN & OUT
This is a standard 5-pin 1800 DIN connector conforming to the MIDI standard
as shown.
From
Impedance-Balanced
Signal +
Output
Screen
From
Signal +
Impedance-Balanced
Output
Screen
Word Clock
75ohm BNC coaxial connector used to lock the Si PERFORMER to other digital
equipment.
HiQNet
Standard 100MB/s RJ45 connector used to connect the Si PERFORMER to a LAN.
Balanced Connection
Signal -
Unbalanced Connection
Signal -
Experience has shown that sometimes it is better
not to connect screen at external device end.
To External Device
To External Device
13