Power Meters And Monitors; Touch Screen Encoders And Buttons - SoundCraft Si Performer User Manual

POWER METERS AND MONITORS

1
2
4
1. 12V LAMP OUT: Connector for LED or similar console light For use with 12v LED lights of
under 100mA only! The intensity of the console lamps may be adjusted from the PREFS
menu and some LED lamps supplied by Soundcraft incorporate a dimming switch on
the lamp itself.
2. USB: Insert a USB key for loading and backup of shows, software updates and similar.
NOTE: The Si PERFORMER supports use of either the front or rear USB port.
3. POWER: Toggles console power ON/OFF; to prevent accidental shut-down a 2-stage
shut-down procedure is required:
a) Press and hold the POWER ON key for ~2 seconds, the power light will flash orange.
b) Confirm shutdown by pressing the POWER ON key again whilst the light is flashing.
If the confirmation is not received within ~5 seconds the POWER ON key will revert to
solid green and the shutdown procedure is cancelled.
NOTE: An 'Auto Start' boot mode is available allowing the console to start booting
immediately after the AC is applied provided the rear AC isolate on the Si PERFORMER
is ON. See Appendix for details.
4. MONITOR meters: Indicates level in the engineers monitor system; this is normally the
LR signal but may be PFL/AFL, or other signal as set in the MONITOR system menus.
5. L, R and MONO meters: Full-time uninterrupted monitoring of the main Left, Right and
Mono buses.
6. 6. SIP , PFL & AFL indicators: Illuminate to show current mode or active state of the SOLO
system.

TOUCH SCREEN ENCODERS AND BUTTONS

1. TOUCH SCREEN: colour touch screen interface.
2. MENU key: Press when lit to return
to the MAIN MENU page.
3. APPLY key: Press when lit to 'APPLY'
a change such as re-naming a cue,
channel, show or similar.
4. SCROLL/ADJUST encoder: Rotate to
scroll up/down lists, press to select or
activate a highlighted function.
20
1
Soundcraft Si Performer User Guide V1.1 1112
3
6
5
2
4
3