Belt Tracking Adjustment; Troubleshooting; Troubleshooting Table - LifeSpan SPRINTER XL User Manual

4.6 Belt Tracking Adjustment:

This treadmill is designed to keep the belt reasonably centred while in use. It is normal
for some belts to drift near one side while the belt is running with no one on it. After a
few minutes of use, the belt should have a tendency to centre itself. If during use, the
belt continues to move toward one side, adjustments are necessary. The procedures are
as below:
▲ First set speed at approximately 3.5km/h.
▲ Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using
6mm Allen Key, until the belt is centered itself; If belt shifts to left, tighten the left bolt
and loosen the right bolt by using 6mm Allen Key, until the belt is centered. When
adjusting the belt using the 6 mm Allen Key, it is important to adjust the belt in half turn
increments. Over adjusting the belt can cause damage to the mat.
If the belts has drifted to the RIGHT
错误！未指定主题。
This treadmill is designed in a way that in the event of an electrical fault, the machine
will turn off automatically to prevent any injuries to the user and to prevent damage to
the machine (i.e. motor).
When the treadmill behaves erratically, simply reset the treadmill by turning the power
switch off, waiting for 1 minute then turning the power button back on.
If, after you have reset the treadmill, it is still not running correctly, please run the self-
checking analyse to distinguish what type of error problem the machine is encountering.

5.1 Troubleshooting Table

错误！未指定主题。
5 TROUBLE SHOOTING
LIFESPAN SPRINTER
If the belts has drifted to the LEFT
Page19