Belt Tracking Adjustment - LifeSpan COMMANDER User Manual

4

.6 Belt Tracking Adjustment:

This treadmill is designed to keep the belt reasonably centred while in use. It is normal
for some b elts to drift near one side while the belt is running with no one on it. After a
few m inutes of use, the belt should have a
belt c ontinues to move toward one side, adjustments
as bel ow:
▲ First set speed at lowest position.
▲ Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using
6mm Hexagonal Wrench, until the belt is centered itself; If belt shifts to left, tighten the
left bolt a nd loosen the right bolt by using 6mm Hexagonal Wrench, until the belt is
cente d. When adjusting the belt using the 6 mm Hexagonal Wrenches, it is important re
to adj ust the belt in half turn incr
the mat.
If the belts has drifted to the RIGHT
tendency to centre itself. If during use, the
are necessary. The procedures are
ements. O ver adjusting the belt ca
If the belts has drifted to the LEFT
LIFESPAN COMMANDER
n cause damage to
Page 19