Ho W To Check The Running Mat For Prope R Lubrication; Belt Tracking Adjustment; Belt Adjustment - LifeSpan BOOMER XT User Manual

Table of Contents

Advertisement

M
edium use (3-5 hours a week) every 3 months
Heavy use (more than 5 hours per week) ever
See below procedures for lubricating:
1.
Use a soft, dry cloth to wi
2.
Spread lubricant onto the inside surface of belt and deck evenly (make sure the machine is turned
power is disconnected).
3.
Periodically lubricat
If
the treadmill belt/deck/roller is kept reasonably clean it is possible to expect over 1200 hours before additional
re-lubing is necessary.
5 Ho
w to check the running mat for prope
1.
Disconnect the main power supply.
2.
Fold the treadmill up into the storage position.
3.
Feel the back surface of the running mat.
If
the surface is slick when touched, then no further lubrication is needed.
If the surface is dry to the touch, apply a suitable silicone lubricant.
W
e recommend you use a silicone based spray to lubricate your Lifespan Treadmill. This can be purchased
from your local sports Ret

6 Belt Adjustment

Belt Tension Adjustment-It is very important for joggers and runners in order to provide a smooth, steady running
surface.
Adjustment must be made from the right and left rear roller in order to adjust tension with the Hexagonal
W
rench provided in the p rts package. The adjustment bolt is located at
below:
Left bolt
Note: Adjustment is thru the small hold on the end caps.
Tighten the rear roller only enough to prevent slippage at the front roller. Tu
clockwise reasonably and inspect for proper tension. When an adjustment is made to the belt tensi
a
lso make a tracking adjustment to compensate for the change in belt tension.
DO NOT OVERTIGHTEN - Over tightenin
7

Belt Tracking Adjustment:

This treadmill is designed to keep the belt reasonably centred while in use. It is normal for some belts to drift
y 6-8 weeks.
pe the area between the belt and deck.
e the front and rear rollers to keep them at there peak performance.
ailer or a local hardware store.
a
g will cause belt damage and premature bearing failure.
r lubrication:
the end of the rails as noted in diagram
Right bolt
rn both the right and left bolt
off and
on, you must
9

Advertisement

Table of Contents
loading

Table of Contents