Table of Contents
Advertisement
adjust tension with the Hexagonal Wrench provided in the parts package. The adjustment bolt is
located at the end of the rails as noted in diagram below:
Left bolt
Note: Adjustment is thru the small hold on the end caps.
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the right and
left bolt clockwise reasonably and inspect for proper tension. When an adjustment is made to the
belt tension, you must also make a tracking adjustment to compensate for the change in belt
tension.
DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature bearing failure.
7. Belt Tracking Adjustment:
This treadmill is designed to keep the belt reasonably centred while in use. It is normal for some
belts to drift near one side while the belt is running with no one on it. After a few minutes of use,
the belt should have a tendency to centre itself. If during use, the belt continues to move
toward one side, adjustments are necessary. The procedures are as below:
▲ first set speed at lowest position.
▲ second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6mm
Hexagonal Wrench, until the belt is centered itself; If belt shifts to left, tighten the left bolt and
loosen the right bolt by using 6mm Hexagonal Wrench, until the belt is centered. When
adjusting the belt using the 6 mm Hexagonal Wrenches, it is important to adjust the belt in half
turn increments. Over adjusting the belt can cause damage to the mat.
8. Solutions for Failure Elimination
Failure
The power supply is connected
and
the
electric
machine has started, however,
there is no any display.
All displays fail to work.
Possible Reason
1 ． The socket and
power supply is not
running
connected well.
2 ． The socket of
electric motor is
not connected well.
3．The fuse is burned.
Keys
are
improperly
10
Solution
1．Insert the socket again.
2．Re-connect the socket.
3 ． Disconnect the power
supply and replace the fuse.
installed
Perfect the installation.
in
Right bolt
Advertisement
Table of Contents
