Belt Tracking Adjustment - LifeSpan entertainer Owner's Manual

rails as noted in diagram below:
Left bolt
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the right and left bolt
clockwise one full turn and inspect for proper tension. When an adjustment is made to the belt tension,
you must also make a tracking adjustment to compensate for the change in belt tension.
DO NOT OVER TIGHTEN - Over tightening will cause belt damage and premature bearing failure. This
may also cause reduced motor performance and excessive roller wear.
NOTE: When properly tightened, the sides of belt can be raised approximate 2-3 inches off the board.

7 Belt Tracking Adjustment:

This treadmill is designed to keep the belt reasonably centred while in use. It is normal for some belts to
drift near one side while the belt is running with no one on it. After a few minutes of use, the belt should
have a tendency to centre itself. If during use, the belt continues to move toward one side, adjustments
are necessary. The procedures are as below:
▲ First set speed at approximately 3.5km/h.
▲ Second check the belt shifts to which side.
ENTERTAINER
Note: Adjustment is thru small hold of end cap.
24
- -
Right bolt