Replacing the system board
To replace the system board:
1
Follow the instructions in
page
25.
2
Follow the instructions in
3
Remove all of the expansion cards. For more information, see
PCI expansion cards" on page
4
Remove the heat sink and processor. For more information, see
the processor" on page
5
Remove the memory modules. For more information, see
memory" on page
6
Disconnect the power and data cables from the system board, noting their
locations and orientation. (You will reconnect the cables after you install
the new board.) Make sure that you disconnect the intrusion switch cable.
7
Remove the system board's thumbscrew.
"Preventing static electricity discharge" on
"Opening the server case" on page
40.
42.
38.
Intrusion switch connector
www.gateway.com
Replacing the system board
"Installing
Thumbscrew
26.
"Installing
"Replacing
47