Table of Contents
Advertisement
3
4
5
6
7
8
9
10
11
12
13
14
Replacing the system board
To replace the system board:
1
2
3
4
5
6
7
44
CHAPTER 4: Installing Components
Record the BIOS settings on your printout, then close the utility.
Turn off your server, then follow the instructions in
on page
18.
Locate the old battery on the system board and note its orientation (see
on page 5
for the general location of the battery). You will need to install the new battery
the same way.
Push the battery retention clip away from the battery until the battery pops up.
Remove the old battery.
Make sure that the positive (+) side of the new battery is facing correctly, then press the
new battery into the socket until it snaps into place.
Follow the instructions in
Turn on the server.
Press F2 when the Gateway logo screen appears during startup. The BIOS Setup utility
opens.
Restore any BIOS settings that you wrote down in
Save all your settings and close the BIOS Setup utility.
Follow the instructions in
Follow the instructions in
Remove the processor air duct by following the instructions in
air duct" on page
21.
Remove the memory modules by following the instructions in
page
34.
Remove all of the expansion cards by following the instructions in
35.
Remove the heat sink and processor by following the instructions in
38.
Disconnect the power and data cables from the system board, noting their locations and
orientation. (You will reconnect the cables after you install the new board.)
"Preventing static electricity discharge"
"Opening the server case" on page
19.
"System board"
Battery retention clip
24.
Step
3.
18.
19.
"Removing the processor
"Installing memory" on
"Replacing the
Advertisement
Table of Contents
Troubleshooting
