Bios - Gateway 920 User Manual

Chapter 6: Troubleshooting
Beeps Description
3 Memory failure in first 64 KB.
4 Memory failure in first 64 KB of
memory, or Timer 1 on the system
board not functioning.
5 The processor on the system board
generated an error.
6 The keyboard controller (8042) may
be defective. The BIOS cannot
switch to Protected mode.
7 The processor generated an
exception interrupt.
8 The server video adapter is either
missing or its memory is faulty. This
is not a fatal error.
9 The ROM checksum value does not
match the value encoded in the

BIOS.

10 The shutdown register for CMOS
RAM failed.
11 The external cache is faulty.
BIOS
The settings in the BIOS Setup utility are not retained
■
Replace the CMOS battery. For more information, see
CMOS battery" on page
72
Troubleshooting steps
Same as for 1 beep.
Remove all expansion cards.
If the beep code occurs even when all
■
expansion cards have been removed, the
system board is at fault.
If the beep code does not occur when the
■
expansion cards have been removed, one
of the cards is causing the problem. Install
the cards one at a time until the problem
happens again. When the beep code
returns, the most recent card you installed
is at fault.
Same as for 4 beeps.
Same as for 4 beeps.
Same as for 4 beeps.
Check or replace the video adapter.
Same as for 4 beeps.
Same as for 4 beeps.
Same as for 4 beeps.
52.
www.gateway.com
"Replacing the