Gateway 920 User Manual page 44

To install or replace memory:
1
Follow the instructions in
page 25.
2
Follow the instructions in
3
Pull the plastic tabs away from the sides of the memory module slot. If
you are replacing a memory module, remove the old module.
4
Align the notch on the new module with the notch in the memory module
slot and press the module firmly into the slot. The tabs on the sides of
the memory slot should secure the memory module automatically.
5
Follow the instructions in
6
Turn on the server. Make sure that the server turns on and that the
operating system loads completely.
7
Restart your server and open the BIOS Setup utility. Verify the amount of
memory installed with the
"Preventing static electricity discharge" on
"Opening the server case" on page
"Closing the server case" on page
listed in the Main menu.
System Memory
www.gateway.com
Installing memory
26.
28.
39