Replacing Cr_Hp Sensor, Lever Sensor - MUTOH ValueJet 1304 Service Manual

VJ-1304 Maintenance Manual

4.12.6 Replacing CR_HP Sensor, Lever Sensor

(1) Replacing W_ON Sensor Relay Assembly, W_OFF Sensor Relay Assembly
NOTE
Remove the screws that retains the board chassis before replacing W_ON sensor relay assembly or
W_OFF sensor relay assembly.
"(1) Removing Board Chassis" p.4-99
1. Remove the cable of the W_ON sensor relay assembly and W_OFF sensor relay assembly from the
connector to the VJ take up unit CNT board assembly.
2
2. Detach the W_ON sensor relay assembly and the W_OFF sensor relay assembly from the CR_HP sensor
and the lever sensor.
2
3. Replace the W_ON sensor relay assembly and W_OFF sensor relay assembly
4. To reassemble the unit, reverse the removal procedure.
CS9050, CS9150
1
1
4-107
4 Parts Replacement
No. Part name
1 VJ take up unit CNT board
assembly
2 Cable of W_ON sensor relay
assembly and W_OFF sensor
relay assembly
No. Part name
1 CR_HP sensor, lever sensor
2 W_ON sensor relay assembly,
W_OFF sensor relay assembly
Rev.-01