Uni-D / Bi-D Low And High Adjustment; Adjustment - MUTOH ValueJet 1304 Service Manual

5 Self-Diagnosis Mode
5.7.6

Uni-D / Bi-D Low and High Adjustment

Adjusts the gap of the print heads (in the CR moving direction) when the head is in the PG Low or High and
the print position of the head in repeatability printing.
To adjust, perform printing in repeatability printing and correct CW and CCW printing positions by inputting
parameters.
*Check the print patterns of origin, center, and opposite side to adjust the gap equally.
Adjustment items are shown below.
Item
Uni-D 240
Uni-D 320
Uni-D 240B
Uni-D 320B
Bi-D 240
Bi-D 320
Bi-D 240B
Bi-D 320B
Item
Set up
Print
(Print2 if "Bi-D" is
selected)
Print1
(Displayed only when
"Bi-D" is selected.)
The actual procedure is as follows.
1. Set media as necessary.
2. After that, printer starts printing automatically.
Rev.-01
CS9050, CS9150
Table 5-7 Uni-D / Bi-D menu items
Adjusts CW at 240 CPS. PG Low or High
Adjusts CW at 320 CPS. PG Low or High
Adjusts CW at 240 CPS-Banner. PG Low or High
Adjusts CW at 210 CPS-Banner. PG Low or High
Adjusts Bi-D at 240 CPS. PG Low or High
Adjusts Bi-D at 320 CPS. PG Low or High
Adjusts Bi-D at 240 CPS-Banner. PG Low or High
Adjusts Bi-D at 320 CPS-Banner. PG Low or High
Table 5-8 Uni-D / Bi-D adjustment items
Sets the selected parameter.
Prints pattern according to the selected item with the
current parameter.
Prints pattern according to the selected item with the
current parameter, plus with the values of ±2 / ±4 / ±6 / ±8
to the current parameter.
Check the gap of those printed patterns.
5-36
VJ-1304 Maintenance Manual
Contents
Contents