Head Alignment (Vertical Slant) - MUTOH ValueJet 1304 Service Manual

VJ-1304 Maintenance Manual

7.9 Head Alignment (Vertical Slant)

This section describes the procedure to adjust the head slant in vertical direction.
After operation such as head assembly replacement, adjust the head slant according to the steps below.
NOTE
Before starting adjustment, remove the following parts.
• CR board cover:
• Cable cover R:
Before aligning print head in vertical direction, perform the alignment in horizontal direction.
"7.8 Head Alignment (Horizontal Height)" p.7-71
In this procedure, align the print head in the direction shown below.
1. Start the system in self-diagnosis function mode and print the adjustment patterns in "Head Slant Check
Menu 2".
"5.7.4 Head Slant Check Menu" p.5-29
CS9050, CS9150
"4.6.1 Replacing Print Head" p.4-56
"4.6.1 Replacing Print Head" p.4-56
Print head
Side view
7-73
7 Adjustment
Rev.-01