Replacement Of Board Base Section Components; Removing Connector Panel And Cooling Fan - MUTOH ValueJet 1304 Service Manual

VJ-1304 Maintenance Manual

4.3 Replacement of Board Base Section Components

This section describes replacement procedures of power board assembly, main board assembly, and cooling
fan.
CAUTION
When you handle a circuit board, do not touch any elements on it with bare hands.
Doing so may cause electrostatic discharge and damage the elements.
4.3.1

Removing Connector Panel and Cooling Fan

(1) Removing Connector Panel
1. Remove the cooling fan (5V) cable from the clamp.
2. Remove the cooling fan (5V) connector.
3. Remove the connector panel screw (tapping screw M3
4. Remove the connector panel.
CS9050, CS9150
3
2
4-21
×
6, S cup: 2).
No. Part name
1 Connector panel
2 Connector panel screw
(tapping screw M3
3 Cooling fan (5V)
4 Parts Replacement
×
6, S cup)
Rev.-01