Releasing Pressure Arms Individually - MUTOH VJ-628 ValueJet Operation Manual

Releasing pressure arms individually

2

Releasing pressure arms individually

When printing on thin media or media without stiffness, the media rubs against the print head and becomes dirty. In such a
case, it may improve when releasing the pressure arms holding both sides of media.
When releasing the pressure arms individually, always conduct paper feed correction.
Note
• Thin media or media without stiffness is likely to be wrinkled during printing. Wrinkles can contact the bottom side of the print head
causing the media to become dirty. When both edges of the pressure arms of media are released, it can prevent wrinkles.
• When printing on thin media or media without stiffness, wrinkles can be prevented by turning down the vacuum fan.
"Setting the vacuum fan" on page 40
Steps
[1]
Open the front cover.
[2]
[3]
[4]
Conduct paper feed correction.
"Correcting paper feed" on page 22
Note
• If media still remains dirty, it may improve by increasing the number of pressure arms to release. In such a case, release the same number
of pressure arms for right and left each.
[5]
Close the front cover.
Turn the media fixing knob to release the lock.
Release the pressure arms on both edges of media.
• Push in the release switch to release.
37