MUTOH VJ-628 ValueJet Operation Manual page 25

[3]
Using a ruler, measure the length between "+" in the pattern.
• In the example below, the measured place is shown in blue dotted lines and arrows (the blue parts are not actually
printed).
[4]
Confirm the measured length.
• If the measured length matches the length selected in Step 1, proceed to
• If the measured length does not match the selected length, re-correct with
3.
Micro adjustment
[1]
Click [Start] in [3-1. Pattern Print] of [3. Micro Adjust].
• A pattern is printed.
[2]
Observe the pattern and verify the micro change value.
• In the pattern, look for a place that has least white lines or overlapping in images.
• The number printed below the pattern is the micro change value.
Not adequate
-0.20
+1.20 +0.80
Adequate Not adequate
-0.50 -0.80
Micro change value
+0.50 +0.20 +0.10
"Micro adjustment" on page
"Checking picture quality" on page
0.00 -0.10 -0.20
21.
-0.50 -0.80 -1.20
Correcting paper feed
19.
25