Releasing The Partial Function Of Pressure Arms - MUTOH DrafStation RJ-901X Operation Manual

RJ-900X series OPERATION MANUAL
3.4.4

Releasing the Partial Function of Pressure Arms

If thin media is creased while printing, release some of Pressure arms.This may prevent getting creases.
Follow the procedure below to release Pressure arms.
1. Raise Media loading lever.
No.
1
2. Push the release switches of Pressure arms further in that are holding the sides of the media.
• When the release switch is set further in, Pressure arms lose the pressure.
No.
1
2
Media loading lever
1
Pressure arms
Release switch
Name
Name
3-25
Before using
1
2
1