Omitting Zones; Installing Users - Abus Secvest 2Way Operating Instructions Manual

Hide thumbs Also See for Secvest 2Way:

Table of Contents

Enlarged version

18.4. Omitting zones

If necessary, you can remove zones from surveillance (e.g. if a detector is

defective or a zone cannot be closed).

Select the Omit Zones menu item.

The system displays all trained zones. Select the zone where the settings

should be changed.

The settings are as follows: M = Monitored / O = Omitted (not monitored)

The setting can be changed here.

When the settings have been made, finish data entry by pressing Done.

These zones are not monitored when the wireless alarm system is activated.

The next time the alarm system is deactivated, these zones are

automatically included again and have to be removed again from

monitoring manually.

As an administrator, you can use your code (master code) to install further

users for the wireless alarm system. Up to 50 users can be installed on the

system. This menu item is also used for training the remote control, the

emergency and panic detectors and the chip key.

Select the User

menu item.

You can now edit user settings, add a new user or delete an existing user

together with all settings.

To edit the user settings, first select the Edit User menu item.

Table of Contents