Abus Secvest 2Way Operating Instructions Manual page 25

Training the chip key
Select Tag. The system
prompts you to hold the chip
key over the system reader.
Hold the chip key over the
alarm system as shown in the
picture. When the system
detects the chip key, it
confirms that training was
successful.
Note: One chip key can be
trained for each user. The
user code remains active.
Training the remote
control without panic
function (FU5155)
Select Telecommands. The
system prompts you to press a
button on the remote control
until the system has detected
and trained the remote control.
Any key can be pressed here.
When the system detects the
remote control, it confirms that
training was successful.
Note:
Up to 20 remote control
units (FU8100, FU5155/5150)
can be trained.
More than one remote
control can be assigned to a
user.
Training the remote
control with panic
function (FU5150)
Training a remote control with
panic function is made in the
same way as the remote
control without panic function
(see above). However, the
panic function is also trained in
this case. The separate
training or deletion of the panic
function is not necessary, and
is also not possible.
When the system has
recognised the remote control,
the panic function and other
normal remote control
functions are activated.
Note:
Up to 20 remote control
units (FU8100, FU5155/5150)
can be trained.
More than one remote
control can be assigned to a
user.
25
Training the wireless
cylinder
Select Telecommands. The
system prompts you to train
the wireless cylinder. Press
the button on the wireless
cylinder and lock the door. The
cylinder sends a learn
message to the wireless alarm
system.
When the system detects the
wireless cylinder, it confirms
that training was successful. A
wireless cylinder is treated
like a remote control unit,
i.e. up to 16 remote controls
and/or wireless cylinders
can be trained. Depending on
which user the wireless
cylinder was trained to, the
user can activate or deactivate
the corresponding areas.
Example: If user 2 is
authorised to control partitions
2 and 3, these two partitions
are activated via the wireless
cylinder.
Training the pendants
(emergency call
transmitters)
The wireless alarm system
can process two types of
emergency transmitters.
These are "Social Care" and
"Panic", which have the same
meaning as the emergency
key functions on the system
keypad. Select Social Care or
Panic. The system then
prompts you to press the
emergency transmitter.
When the system detects the
emergency transmitter, it
confirms that training was
successful.
Note: Up to 16 emergency
transmitters can be trained.
This number includes the
other emergency
transmitters (social care and
panic).
One emergency transmitter
and one panic transmitter
can be trained per user.