Abus Secvest 2Way Operating Instructions Manual page 28

Hide thumbs Also See for Secvest 2Way:
Table of Contents

Advertisement

System Rearmed
The system has automatically reactivated itself
following an alarm.
U-- Z== Omit
User -- has omitted zone ==.
Fire Z== Alarm
Zone == has triggered a fire alarm.
Fire Z== Restore
The fire alarm was confirmed.
Fire Reset
The fire alarm was confirmed on the control
panel.
PA Z== Alarm
Zone == has triggered a panic alarm.
PA Z== Restore
The panic alarm of zone == was confirmed.
U-- System Reset
User -- has reset the system.
Fire K== Alarm
A fire alarm was triggered on the control panel.
PA K== Alarm
A panic alarm was triggered on the control panel.
Medical K== Alarm
A medical emergency was triggered on the
control panel.
Burg Z== Alarm
Zone == has triggered an burglar alarm.
Set Fail Z==
System activation has failed due to an error in
zone ==.
Burg Z== Restore
The burglar alarm was confirmed.
Tamper Z==
Zone == has triggered a tamper alarm.
Tamper Z== Restore
The tamper alarm was confirmed.
K== Excess Keys
The extra keys on the control panel were
activated.
Low Bat Z==
The battery of the detector in zone == must be
replaced.
Low Bat Z== Rstr
The battery in this zone is OK again.
RF Jamming
Wireless jamming has occurred. The wireless
transmission was disturbed for at least 30
seconds within one minute.
RF Jamming Restore
The jamming report was confirmed.
RF Sup Fail Z==
Supervision has failed in zone ==. This zone has
not reported to the system for 2 hours.
RF Sup Rstr Z==
The supervision failure message was confirmed.
PSTN Line Fault
Error in the analogue telephone line.
PLGON Line Fault
Transmission error via ISDN/GSM.
Entry
Meaning
PSTN Line Restore
Error in analogue telephone line was confirmed.
PLGON Line Restore
Error in ISDN/GSM transmission was confirmed.
Comms Fail
Error during transmission to security centre.
U-- Remote Download
User -- has carried out remote maintenance.
U-- Download Fail
User -- has an error in remote maintenance.
AC Fail
Power failure.
AC Restore
The power failure was confirmed.
Low Battery
The system battery is not charged.
Low Batt Restore
The battery error was confirmed.
Battery Load Fail
The battery cannot be charged.
Tech Z== Alarm
Zone == has triggered a technical alarm.
Tech Z== Restore
The technical alarm was confirmed.
U-- Time/Date
User -- has changed the date or time.
Soak Fail Z==
Detector test in zone == has failed.
Test Call
The system has made a test call.
Bad Checksum
Misinterpretation in wireless transmission.
U-- Soc. Emergency
A social care emergency has been triggered.
Social Inactive
The social care function has been deactivated.
Key Box Open Z==
The key box in zone == was opened.
Key Box Close Z==
The key box in zone == was closed.
Key Sw Set Z==
The key switch of zone == has activated the
system.
Key Sw Unset Z==
The key switch of zone == has deactivated the
system.
U-- Ptn # Reset
User -- has reset the partition.
RF Failure
Error in wireless transmission.
RF Failure Restore
Wireless transmission is OK again.
Social Emergency K==
A social care emergency was triggered on the
control panel.
Fire Restore K==
The fire alarm was confirmed.
PA Restore
The panic alarm was confirmed.
U-- Ptn # PtSet
User -- has activated a partition internally.
PA U-- Alarm
User -- has triggered a panic alarm.
RF PA U-- Low Bat
The panic detector battery must be replaced.
Entry Stray Z==
Zone == has triggered an alarm during the entry
delay time.
28

Advertisement

Table of Contents
loading

Table of Contents