Neck Support - Otto Bock Kimba neo Instructions For Use Manual

Usage
Adjusting the groin strap
The adjustment of the final belt tension takes place when putting it on as follows:
• Adjusting the belt length at the two clips on the back of the seat (see Fig. 63, item 1).
• Adjusting the belt in the strap adjustment at the leg straps (see Fig. 64, item 1).
Putting on the groin strap
1) If needed: Open the clip buckles and pull the belt straps of the leg straps to the front somewhat (see Fig. 63,
item 1).
2) Open the two clips at the leg straps by pressing on the fastener tabs (see Fig. 64, item 1).
3) Place the user on the groin strap and thread the leg straps between the legs and over the thighs to the outside
(see Fig. 62).
4) Close the two clips at the leg straps (see Fig. 64, item 1).
5) If needed: Tighten the belt straps in the clip buckles at the back of the seat and fasten them (see Fig. 63,
item 1).
6) By pulling on the free belt ends in the belt adjustment, the length of the leg straps can be adjusted, if needed
(see Fig. 64, item 2).

6.8.7.7 Neck Support

The shaped padding helps to immobilise the user's head in the rehab buggy.
The option has already been installed by qualified personnel.
32 | Ottobock
62
64
63
Kimba neo