Icom IC-F9011 User Manual page 66

•Hunt List
Even if the available number of control channels in a
list has been set in Capacity in the List Operation
screen, you can add or delete a channel in each list.
To create a new channel, point to the cell on the
[New] line which is located at the bottom of the
screen, then double click or right click to display the
Edit menu and click [Edit...Enter] to create a new
channel.
•Valid
This function validates entry into the channel.
Select "ON" to validate the entry.
•RX Select the way to set downlink frequencies of
control channels.
CH ID Only
CH Freq Only
•RX CH ID Enter a control channel ID from broadcast
channel structure to set a downlink frequency. The
ID is defined by TIA TSB-102. AABD.
•RX CH Number
Enter a control channel number from the broadcast
channel structure to set a downlink frequency. h l
The number is defined by TIA TSB-102. AABD.
•RX Freq
Enter a downlink frequency of a control channel in
Hertz (Hz).
▒ ▒ NOTE:
▒ The value must match to the value calculated
▒ from a channel broadcast.
•TX
Select the way to set uplink frequencies of control
channels.
CH ID Only y
CH Freq Only
66
APCO P25 Trunking –
Clone Soft Setting
Set a downlink frequency of a
control channel in RX CH ID
and RX CH Number.
Set a downlink frequency of a
control channel in RX Freq.
d li k f
Set an uplink frequency of p q
control channel in TX CH ID
and TX CH Number.
Set an uplink frequency of
control channel in TX Freq.
•TX CH ID
Enter a control channel ID from the broadcast
channel structure to set an uplink frequency. The ID
is defined by TIA TSB-102. AABD.
•TX CH Number
Enter a control channel number from the broadcast
channel structure to set an uplink frequency. The
number is defined by TIA TSB 102. AABD. number is defined by TIA TSB-102. AABD.
•TX Freq
Enter an uplink frequency of a control channel in
Hertz (Hz).
▒ NOTE:
▒ The value must match to the value calculated from
▒ a channel broadcast. ▒ a channel broadcast
Roaming List
•List Operation
q
•Capacity
Set the available number for the Roaming.
When "5" is entered in Capacity of Roaming List1,
Roaming List1 has 5 addresses. A total of 4
roaming list settings are available, and each list can
have up to 10 addresses. p
•List
Even if the available number of roaming areas in a
y
list has been set in the Capacity item in the List list has been set in the Capacity item in the List
Operation screen, you can add or delete an area in
each list.